Instruction Manual

PMT INSTALLATION

Introduction Parts Description Operating Instructions Internet Updates Appendix

SECTION 5: HOW TO DOCK THE PMT (make sure that the vehicle key is o)

The PMT and cradle can be damaged if the PMT is not carefully placed onto the cradle. See the

diagrams below for proper installation. Note that the diagrams show the PMT being docked on to

the dash/windshield mounting styles, but the PMT docking instructions are the same for the A-Pillar

mount as well.

1. Make sure that the docking port on the bottom

part of the cradle is ipped forward as far as it

will go.

2. Dock the PMT onto the cradle.

3. Once docked, rotate the PMT back and snap it

into the cradle.

Removing the PMT:

1. When removing the PMT, simply press down on the top part of the PMT that snaps into the top of

the cradle.

2. Rotate the PMT forward on the docking port.

3. Pull the PMT up and out of the cradle.

Note: Check the cradle swivel to make sure that

it is connecting up to the PMT correctly. The bot-

tom of the swivel should be ush with the bottom

of the PMT.

PMT Installation