Owner manual

Custom Pod Mount Install

6. Install the appropriate mount adapter and run cables

for your vehicle through the accessory hole in the Bully

Dog A-pillar as needed. (Some route out through, while

some mount back in before install) Pull the driver side

dash panel o to run cables under the dash to the

OBDII Plug.

7. Install Bully Dog A-pillar by

guiding the push pins into the

appropriate hole and pushing

it until it locks in place.

8. Install visor trim piece.

9. Reinstall visor.

10. Finish by inserting plastic

screws.

11. Enjoy the sleek new look of your

Custom Mounted Bully Dog GT!