Owner's manual

6
RAPID FLOW INDUCTION
3. Install the stock rubber grommets in the two
holes at the base of the RFI system.
4. Align the RFI system so that the air lter points
towards the outside of the vehicle, and press
down to secure the RFI in place.
5. Attach the air sensor to the sensor holder on
the RFI system. To attach the air sensor, press
the air sensor into the sensor holder twisting it
until the key aligns and the sensor head pokes
through the holder. Turn the sensor clockwise
¼ of a turn to secure the air sensor.
6. Secure the RFI System by using the Stock Nut
and tightening with a 10mm end wrench.
Install Grommets in Base of RFI
Press RFI into place
Air Sensor Holder
Air Sensor
Secure Stock Nut
Introduction Stock Removal RFI Installation Filter Maintenence
Troubleshooting/FAQ
Warranty/Disccliamer
Attach Air Sensor
Secure RFI with nut