Owner's manual

4. Locate the air sensor on the right side of the

intake. Remove the sensor from the intake

by twisting it counter clockwise and pulling

it out.

5. Remove the nut at the back right side of

the intake by removing with a 10mm end

wrench. (Save this nut for later use). Finally

remove the intake from the vehicle by pull-

ing it straight up to release it from the two

rubber grommets which hold it in place. If

the grommets come o with the intake

housing, remove them from the intake hous-

ing and store for later use.

RAPID FLOW INDUCTION

Remove Air Sensor

Air Sensor

Remove Nut

Introduction Stock Removal RFI Installation Filter Maintence

Troubleshooting/FAQ

Warranty/Disccliamer

Note: it is recommended that you use a silicone spray to make removing the rubber grommets from

the stock intake easier.