Owner's manual

3
RAPID FLOW INDUCTION
rEmOvINg ThE STOCk INTAkE
In these steps you will remove the stock intake system.
1. Locate the stock air intake inside the en-
gine bay on the driver side of the vehicle
towards the front of the engine bay.
2. Remove the intake hose from the stock
intake using a at head screw driver to
loosen the clamp.
3. To make removal of the stock intake
easier, remove the intake cover by un-
screwing the two at head screws on
the top of the intake. Then remove the
cover and the stock air lter.
Locate Stock Intake
Remove Intake Hose
Remove Flat Head Screws
Introduction Stock Removal RFI Installation Filter Maintenence Troubleshooting/FAQ Warranty/Disccliamer