Instruction Manual

VALVE BODY MODIFICATIONS

The diagram below shows the dierent shift plug locations and the actuator location for reference.

1. Remove the retaining clip from the valve body that is holding the shift plug by placing a ¼ in. bolt into the

shift plug and slightly pushing it in to relieve the pressure of the clip then remove the clip with a pick tool.

2. Using the ¼ in. bolt, move the rst of the three shift plugs with a side to side motion to gain access to the

spring as seen in the photo below. Remove the spring and place the new Bully Dog Spring inside the old spring

as seen in the photo.

Modications

ACTUATOR

SHIFT PLUG