INSTALLATION MANUAL Shift Enhancer Applications Ford 7.
TABLE OF CONTENTS INTRODUCTION Get ready for greatly improved shift over stock shifting; this stage 1 shift enhancer will give you a noticeably better shift with a more positive engage. Your ‘99-’03 Ford 7.3L auto will be shifting better than ever before. Before beginning installation be sure that the truck has sat long enough for the transmission to completely cool down. TABLE OF CONTENTS INTRODUCTION................................................................................................PG.
Parts Contents: • Springs (3) • Actuator • Rubber O-ring Parts included: THE SPRINGS: The three springs included with this kit will actually slide inside of existing springs in the valve body to help add pressure to the existing springs. ACTUATOR: This actuator will replace one of the existing actuators in the valve body. RUBBER O-RING: The o-ring included with the kit goes around the new actuator. In the photo above the Oring is already on the actuator.
Removing Valve Body REMOVING THE TRANMISSION VALVE BODY Important: When dismantling the valve body, be careful to store all of the parts in a safe place to prevent them from being lost. It is also very important to keep all the parts clean. 1. Remove the transmission oil from the pan; some transmission pans do not have drain plugs, so the pan will need to be tipped to the side to drain the oil. You will need to use a 10 mm socket to remove the bolts that attach the pan to the transmission. 2.
Modifications VALVE BODY MODIFICATIONS The diagram below shows the different shift plug locations and the actuator location for reference. ACTUATOR SHIFT PLUG SHIFT PLUG SHIFT PLUG 1. Remove the retaining clip from the valve body that is holding the shift plug by placing a ¼ in. bolt into the shift plug and slightly pushing it in to relieve the pressure of the clip then remove the clip with a pick tool. 2. Using the ¼ in.
Modifications 3. Replace the shift plug and retaining clip and use the same procedure on the other two shift plugs located on the valve body. 4. To remove the actuator, simply press in on the actuator face to relieve tension and then remove the retaining clip that holds the actuator in place. 5. Replace the existing actuator with the new Bully Dog actuator. Make sure the new O-Ring is in place on the actuator.
Notes 6
Doc.# 151000-99 V1.1 Check out more of our ADRENALINE PUMPING products! Downloaders Intake Systems Triple Dog GT Exhaust Systems ® Free Technical Support at: 866-bullydog (866-285-5936) See More at: bullydog.