Owner`s manual

ManualsBrandsBullFrog ManualsHome building and DecorSpas

PREMIER CONTROL SYSTEM

Note: The pump responsible for heating and filtration (pump 1 low-speed) will be referred to simply as the

pump.

Timeouts refer to a preset length of time that a function is programmed to operate before shutting off

automatically. Certain conditions (filters or freeze) can cause a function to operate longer, while faults

can cause a function to operate for a shorter length of time. The system keeps track of timeouts

regardless of other conditions.

In multi-button sequences, if buttons are pressed too quickly they may not register.

Initial Start-Up

When your spa is first actuated, it will begin the Priming mode. The Priming mode will last for up to 4

minutes, and then it will begin to heat. The water temperature will be maintained during the Standard

mode. You can exit the Priming mode early by pressing WARMER or COOLER.

Icon Legend

1. Setting the Time

Once the spa has been properly connected, notice the

“Time” icon appearing on the screen.

Press Then

Select the hour by pressing

(Each press changes the time by 1 hour)

Select minutes by pressing

(Each press changes the time by 1 minute)

Press

to exit the time setting procedure

and enter the optional filter cycle

programming.

to exit programming.

2. Optional Filter Cycle Programming

You are not required to set filter cycles; however, it is

an option available to you. To change the filter cycle

settings: Press “Time” “Mode/Prog” “Mode/Prog” “Mode/

Prog” within 3 seconds. You will see the “PROGRAM,”

“FILTER 1” and “START TIME” icons appear on the dis-

play. Press “Warmer” or “Cooler” to choose the filter

start time hour. Enter the hour by pressing “Mode/

Prog” . Press “Warmer” or “Cooler” to choose the filter

start time minutes. Each press changes the start time by

5 minutes. Enter the minutes by pressing “Mode/Prog.”

Press “Mode/Prog” to see the “PROGRAM,” “FILTER 1”

and “END TIME” icons. Adjust the time as done above.

Press “Mode/Prog” to see the “PROGRAM,” “FILTER 2”

and “START TIME” icons. Proceed as above.

Press “Mode/Prog” to see “PROGRAM,” “FILTER 2” and

“END TIME” icons. Adjust the time as done above.

Pressing “Mode/Prog” will enter the new filter cycle

times into the system and display the current water

temperature.

Pressing “Time” at any time during this programming

sequence will save the values entered up to that point

and exit programming.

Bullfrog Spas Owner’s Manual