Owner`s manual

24
Operation
Control System
IMPORTANT: Each Bullfrog Spa is manufactured with either a
Select or Premier Control System. Each Tadpole Hot Tub is
manufactured with a Basic Control System. Refer to the
Control System that applies to your spa.
WARNING: This equipment generates and uses radio
frequency energy and if not installed and used properly, that
is, in strict accordance with the manufacturer’s instruction,
may cause interference to radio and television reception.
It has been type tested and found to comply with the limits
for a Class B computing device in accordance with the
specications in subpart j of part 15 of the FCC rules, which
are designed to provide reasonable protection against such
interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause interference, which
can be determined by turning the equipment on and off, the
user is encouraged to try to correct the interference by one
or more of the following measures: Reorient the receiving
antenna. Relocate the receiver with the respect to the spa.
Move the receiver away from the spa. Plug the receiver into
a different outlet so the receiver and spa are on different
branch circuits and if necessary, consult your authorized
Bullfrog Spa dealer or an experienced Radio/Television
Technician for additional suggestions. You may nd the
following booklet prepared by the Federal Communications
Commission helpful, How to Identify and Resolve Radio-TV
Interference Problems. This booklet is available from the U.S.
Government Printing Ofce, Washington, DC 20402, and
stock number 004-000-00345-4.
Select and Basic Control Systems
General
The pump responsible for heating and ltration is pump 1.
Timeouts refer to a preset length of time that a function is
programmed to operate before shutting off automatically.
Certain conditions (lter or freeze) can cause a function to
operate longer, while faults can cause a function to operate
for a shorter length of time. The system keeps track of
timeouts regardless of other conditions. NOTE: In multi-button
sequences (shown by the + sign), if subsequent buttons are
pressed too quickly the desired result may not occur.
Initial Startup
Before turning on the power to the spa, make sure the spa is
properly lled with water and the equipment door has been
secured. When your spa is rst actuated, it will begin the
Priming mode. The Priming mode will last for up to 4 minutes,
and then the control system will begin to heat the spa and
maintain the water temperature in the Standard mode. Press
temp to exit the Priming mode early.
Temp Set: 80
◦
F-104
◦
F (26
◦
C-40
◦
C)
The startup temperature is set to 100
◦
F (38
◦
C). The last
measured temperature is constantly displayed on the Liquid
Crystal Display (LCD). NOTE: The spa temperature displayed
is only current when the pump has been running for at least
2 minutes.
Press temp once to display the set temperature. To change
the set temperature, press temp a second time before the
LCD stops ashing. Press temp additional times to increase or
decrease the set temperature. After 3 seconds, the LCD will
automatically display the last measured temperature.
NOTE: To reverse the temperature adjustment direction,
pause 3-5 seconds between pressing temp.
Spa Operating Modes
A multi-button sequence is used to switch between Standard,
Economy, and Sleep modes. Press temp + light to enter mode
programming. Press temp to cycle through to desired mode,
then press light to conrm selection.
Operation
lightlight
temptempjets 1jets 1 aux
Select Control System One Pump
lightlight
temptempjets 1jets 1 jets 2jets 2
Select Control System Two Pumps
Basic Control System