Instructions / Assembly

OPERATION INSTRUCTIONS
SETTING THE TEMPERATURE CONTROL
 Your unit has only one control for regulating the temperature in the compartment. The temperature control is located on the upper right hand side
of the compartment.
 The first time you turn the unit on, set the temperature control to “6”.
 The range of the temperature control is from position “OFF” to “6”. After 24 to 48 hours, adjust the temperature control to the setting that best
suites your needs. The setting of “3” should be appropriate for home or office use.
 To turn the appliance off, turn the temperature control to “OFF”.
Note: Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the power to the unit. If the unit is unplugged,
has lost power or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the unit will
not start.
ELECTRICAL
Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage can detrimentally affect the
refrigeration unit. All units should be plugged into a grounded and properly-sized electrical outlet with appropriate overcurrent protection. Please
refer to the electrical requirements on the nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord.
STORING FOODS
 Foods to be stored in the refrigerator should be properly packed so as to prevent mixing various moisture degrees and odors.
 Make sure that foods do not touch each other. Assure adequate air circulation around packages.
 Never store flammable, volatile or explosive substances.
 Beverages with high alcohol percentage shall be stored in tightly sealed bottles in a vertical position.
 Food should not touch the rear wall of the refrigerator.
 Try not to open the door too often.
 Make sure to remove perishable articles of food out of the appliance before you leave for a long time.
6