Energy Guide

INSTALLATION INSTRUCTIONS
 If the unit has recently been transported, please let unit stand still for a minimum of 24 hours before plugging it in.
 Make sure that the unit drops down to desired temperature before loading the unit with product.
 Make sure that there is proper ventilation around the unit in the area where it will operate.
 Make sure all accessories are installed (for example shelves, drawer, etc.) before plugging the unit in.
CABINET LOCATION GUIDELINES
 Install the unit on strong and leveled surfaces.
- Unit may make unpleasant noises if surface is uneven.
- Unit may malfunction if surface is uneven.
 Install the unit in a dry, well-ventilated area.
- Unit should be away from direct sunlight; extreme cold ambient temperatures may also cause the unit not to perform properly.
 Avoid installation in a high humidity and/or dusty area.
- Humidity could cause unit to rust and decrease efficiency of the unit.
- Dust collected on condenser coil will cause unit to malfunction. Clean the condenser at least once a month with a brush or clean cloth.
 Avoid placing the unit near heat emitting devices (for example cooking appliances, radiators, water heaters, or similar devices) and moisture-
generating equipment.
- High ambient temperatures will cause the compressor to overwork, leading to higher energy bills and gradual breakdown of the unit.
The unit must have more than 4 inches of clearance from the cabinet to any walls for ventilation purposes.
- Since this product has many ventilation holes underneath, please make sure there is a gap of at least 1 inch between the bottom of the product
and the ground. Also make sure there is nothing stuck underneath.
3
READ CAREFULLY BEFORE INSTALLATION OF YOUR REFRIGERATOR