Use and Care Guide

7
Your EZ Shear SST cuts a wide variety of products.
Please refer to this cut guide for recommended
products and thicknesses.
Material
Max Thickness
Siding, Fiber Cement Board 12mm or 1/2"
Siding, Pressboard Lap 18mm or 3/4"
Siding, Vinyl 25mm or 1"
Siding, Wood 25mm or 1"
Trim, OSB 25mm or 1" *
Trim, Fiber Cement 25mm or 1"
Trim, Vinyl 25mm or 1"
Shingles, Tar or Wood 12mm or 1/2"
Commercial Vinyl 24mm or 1"
Cork 24mm or 1"
Engineered Wood Refer to pg. 8
Laminate Flooring 15mm or 5/8"
Leather 25mm or 1"
Luxury Vinyl Tile 25mm or 1"
Parquet 12mm or 1"
Permastone
™
6mm or 1/4"
PVC Tile 25mm or 1"
Recycled Tire Tile 25mm or 1"
Rubber Cove Base 12mm or 1"
Rubber Tile 25mm or 1"
Soft Plastic 25mm or 1"
Tirex
™
& Rope Cord 25mm or 1"
Please note: Approved materials may vary in density and hardness. If extreme pressure is required to cut a product, it may result in damage
to your machine. Please contact Bullet Tools before proceeding. Warranty is void if an unapproved product damages the machine.
IMPORTANT
If cutting 1” thick OSB trim,
limit the width to 6”
Honing the Blade
Greasing / Lubricating
MAINTENANCE
ACCESSORIES
SST CUT GUIDE
Push the handle down until blade is 1/4” (6mm) open.
Lay the hone stone against the at face of the blade
(side toward the table) and slide from end to end 2 or 3 times.
This removes the small burr formed when cutting hard
products.
Hone every 100 cuts
After every 100 cuts, it is recommended that you lubricate
the wear points of the pins and the bearings as shown. Use
a light oil (i.e. 10W motor oil). This will prevent the machine
from wearing out prematurely. Apply grease frequently to
the bearings where indicated�
Oil
Grease
Angle Guide
(13” model only)
Item #113AG
Set any angle from 0
º
to 90
º
Mounting Bracket
Item #100MB
Brackets for mounting your shear to a stand
Shear Stand
Item #709
Allows you to cut with the shear
off the ground�