Use and Care Manual

2
While gently pushing handle
down, pull Safety Lock pin
out, then lift handle.
Place product on table.
Bring handle down until
blade touches material.
Push handle down until
material is completely cut.
3
DO NOT USE ON HIGH PRESSURE LAMINATE OR SOLID WOOD!
USING YOUR SHEAR
1
FLR CUT GUIDE
Max Thickness = 5/8” or 15mm
Material List
Laminate Flooring
Engineered Wood
Commercial Vinyl
Luxury Vinyl Tile
Parquet
PVC Tile
Rubber Tile
Soft Plastic
SST CUT GUIDE
Max Thickness = 1” or 25mm
Material List
Siding, Fiber Cement Board
Siding, Pressboard Lap
Siding, Vinyl
Siding, Wood
Trim, OSB
Trim, Fiber Cement
Trim, Vinyl
Shingles, Tar or Wood
Your EZ Shear cuts a wide variety of products. Please refer to cut guide for recommended products and thicknesses.
Please note: Approved materials may vary in density and hardness. If extreme pressure is
required to cut a product, it may result in damage to your machine. Please contact Bullet Tools
before proceeding. Warranty is void if an unapproved product damages the machine.
For full manuals, warranty info,
accessories, & tips on using and
maintaining your EZ Shear, go
to BulletTools.com or scan
the QR code below.
PRT-INS-QEZA REV.A.3.15 ©Bullet Tools
Hayden, ID USA • 208-772-0175