Product Manual

FX and PX Series Helmets
FX and PX Series Helmets
1) Pull visor down to
“as worn” position
2) Flip finger latches open on both sides 3) Remove visor lens
5) Slide lens into retainer, matching the notch with
mating part inside retainer
6) Flip latches closed
4) Clean visor with mild
soap, rinse thoroughly
with clean water, and dry
with a soft cloth
Cleaning
Remove ear/neck protector, headband, and crown straps. Clean inner and outer
shells with mild soap or detergent. Wash the ear/neck protector, headband, brow
pad, crown pad, and crown straps in warm, soapy water and air dry at room
temperature. Clean faceshields with mild detergent, rinse thoroughly with clean
water, and dry with a soft cloth.
Users should not wear helmets that are not thoroughly cleaned and dried.
Contamination and Decontamination:
Special precautions must be taken if your protective helmet becomes contaminated
with chemical or biological hazardous materials. The guidance for these
precautions should be coordinated with the appropriate (local, state, and federal)
authorities having jurisdiction for hazardous materials (HAZMAT).
Contaminated helmet ensembles should be isolated, contaminate(s) identified,
and bodily contact should be avoided. Avoid spreading the contamination
to interior spaces of buildings or vehicles, any living quarters, or personal
belongings. If possible, seal the contaminated ensemble in a leak proof, sealable,
air tight container. Disposal should be done in adherence to local, state, and
federal laws. If the helmet is to be reused, it MUST be decontaminated before
reuse. Decontamination should be performed using procedures established by
decontamination professionals that will remove contaminate(s) while minimizing
damage or compromise to the helmet. Failure to do so could result in increased
risk of injury, illness, disease, or death.
Bullard Fire Helmet Warranty
Bullard offers a best in class warranty. Bullard warrants to the original purchaser
that the firefighter helmet and non-electronic components are free of defects in
materials and workmanship under normal use and service for a period of five (5)
years from the date of manufacture on the helmet shell and lifetime (as defined in
NFPA 1851: ten years) warranty on the non-electronic components. The Bullard
obligation under this warranty is limited to repairing or replacing articles that are
returned within the warranty period, shown to be defective after inspection by
Bullard, and subject to the following limitations:
Helmet must be returned to Bullard with shipping charges prepaid
Helmet must not be altered from its original factory configuration
Helmet must not have been abused, neglected or damaged in transport
In no event shall Bullard be responsible for consequential damages incurred by the
user or a third party, whether those damages include loss of use or other indirect,
incidental, or consequential damages, special costs or expenses Bullard offers no
warranty on components or accessories NOT manufactured or supplied by Bullard.
ANY IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO FIVE
(5) YEARS ON THE HELMET SHELL AND LIFETIME (NFPA 1851: TEN YEARS) ON THE
NON-ELECTRONIC COMPONENTS FROM THE DATE OF MANUFACTURE OF THIS
PRODUCT.
RETURN AUTHORIZATIONS: Contact Customer Service to obtain written permission
to return any product. Material returned for credit will be subject to factory
inspection. Current products or products under warranty will be subject to a
rehandling charge less original freight charge. Obsolete or special order products
cannot be returned without written permission.
www.bullard.com
WARNING
Do not use solvents or paint thinners on Firedome helmets, as they could
permanently mar surfaces or degrade the protective properties of helmet
components. Touch-up painting on composite outer shells can be done with
Bullard-approved paints. Failure to follow these instructions could reduce the
effectiveness of the helmet and result in death or serious injury.