EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System www.bullard.
Contents Return Authorization......................................................................................12 Approvals and Certifications ..........................................................................2 Limitations of Use and Warnings ...................................................................2 System Components........................................................................................3 Pre-Operational Inspection ....................................................
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System System Components EVA with Belt LF-Series RT-Series EVA Battery Charger PAPRFC3 PAPRFC4 / PAPRFC5 EVA Battery Air Flow Indicator Breathing Tube Filter / Cartridges Bullard Filter No.
1 Pre-Operational Inspection Before each entry into a contaminated area, the following inspection must be performed to ensure proper function of the respirator system. If damage is found on any component, do not use. 1. PAPR System • Closely inspect the entire EVA Powered Air-Purifying Respirator (PAPR) system including the filter / cartridge, battery, hood and breathing tube. Pay attention to component connection points for wear and damage.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System 2. Belt and Backpack Assembly 3. Filter / Cartridge Installation a. With the turbo-blower unit filter side down, orient the lever locks as shown. a. Remove the filter / cartridge from its packaging and inspect for damage to the gasket and filtering media. a. b. Lay the belt over the turboblower lever locks as shown. b.
Guidance for Selecting LF-Series Hood The LF-Series hood is available in two (2) widths and three (3) sizes in each width to accommodate various face and head sizes for maximum comfort and protection. The 20LFHE hoods have a built-in PTFE-based HEPA panel along the jaw of the hood. It is intended to block large-particle droplets, splashes, sprays, or splatter from entering the hood.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System Guidance for Selecting the Appropriate Breathing Tube Length EVA Belt 6. Don the hood according to the type of hood selected. See LF-Series Hood Donning Procedures or RT-Series Hood Donning Procedures 7. Make any final adjustments to the fit as required to ensure a comfortable and stable fit.
RT-Series Hood Donning Procedures LF-Series / RT-Series Useability Guidance 1. Locate and connect the unattached end of the nylon strap with Velcro to the opposite side of the hood. This provides the overall shape of the hood and lens. • S pecial consideration should be taken for users with long hair in a ponytail-style to ensure the hood remains secure on the head.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System Airflow Test with Airflow Indicator Pass With the turbo-blower unit turned ON, breathing tube connected to turboblower unit, and the filter / cartridge installed, place the upright- positioned Airflow Indicator onto the free end of the breathing tube.
Storage Store the PAPR and its components where they will be protected from contamination, distortion, and damage from elements such as dust, direct sunlight, heat, extreme cold, excessive moisture, and harmful chemicals. Temperature should be between -5°C to 54°C (23°F to 129°F) with humidity less than 90% RH, except Filter Storage should be between 0°C to 32°C (32°F to 90°F) with humidity less than 90% RH.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System Understanding Alarms Active Flow Technology Low Battery Alarm The Low Battery Alarm will sound an intermittent electronic beep indicating that there is approximately fifteen (15) minutes of remaining battery capacity. The delays between beeps will get shorter and shorter as time runs out. The battery indicator LED will turn red.
Product Warranty any way purporting to modify this warranty shall be binding upon Bullard, unless made in writing and signed by an authorized employee of Bullard. E.D. Bullard Company (manufacturer) warrants to the original purchaser that the EVA Powered Air- Purifying Respirator, hoods, battery, and charger will be free of defects in material and workmanship under normal use and service for a period of one (1) year from the date of purchase. E.D.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System Parts and Accessories EVA Breathing Tube Covers & Lenses EVA1EU Turbo-blower Unit only EVA2EU Turbo-blower, Hood Battery, Charger, no filter EVA2EUDB Turbo-blower, Vinyl Decon Belt, Hood Battery, Charger, no filter EVA3EU Turbo-blower, Hood Battery, no Charger, no filter EVA3EUDB Turbo-blower, Vinyl Decon Belt, Hood Battery, no Charger, no filter EVA4EU Turbo-blower, Hood Battery, no Charger, PAPRFC3 EVA4EUDB Turbo-
www.bullard.
EVA (with LF-Series and RT-Series Hoods) Powered Air-Purifying Respirator (PAPR) System www.bullard.
Bullard Center 2421 Fortune Drive Lexington, KY 40509 • USA 877-BULLARD (285-5273) Tel: +1-859-234-6616 Fax: +1-859-246-0243 E.D. Bullard Company Manufacturer 1898 Safety Way Cynthiana, KY 41031 • USA 877-BULLARD (285-5273) Tel: +1-859-234-6616 Fax: +1-859-234-8987 Bullard GmbH Dieselstrasse 8a 53424 Remagen • Germany Tel: +49-2642 999980 Fax: +49-2642 9999829 www.bullard.com Bullard Asia Pacific Pte. Ltd.
