User`s guide

4-10
Server
Option Parameter Description Your Setting
System
Management
– Displays the System Management
submenu.
Console
Redirection
– Displays the Console Redirection
submenu.
BMC LAN
Configuration
– Displays the BMC LAN
Configuration submenu.
Event Log
Configuration
– Displays the Event Log
Configuration submenu.
Assert NMI on
PERR
Disabled
[Enabled]
Enables or disables PCI PERR
support.
Assert NMI on
SERR
Disabled
[Enabled]
Enables or disables PCI SERR
support.
FRB-2 Policy Disable FRB2 Timer
Disable BSP
Do Not Disable BSP
[Retry 3 Times]
Sets the FRB level 2 timer.
Boot Monitoring [Disabled]
5 Minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
35 minutes
40 minutes
45 minutes
50 minutes
55 minutes
60 minutes
Enables or disables the boot
monitoring function, or selects the
time limit for the timeout.
To use this function, install the NEC
ESMPRO Agent.
Set this item to "Disabled" if the
system is booted from the OS and
no NEC ESMPRO Agent is installed.
Boot Monitoring
Policy
[Retry 3 Times]
Always Reset
Specifies the action when a timeout
occurs during the boot monitoring.
If [Retry 3 times] is selected, the
system is reset after the occurrence
of the timeout and the OS boot is
retried up to three times.
If [Always Reset] is selected, the
system is reset after the occurrence
of the timeout and the OS boot is
retried repeatedly.
* If no service partition exists in the
system, the OS boot is retried
repeatedly from the system
partition.
Thermal Sensor Disabled
[Enabled]
Enables or disables the thermal
sensor monitoring function. If a
thermal error is detected and this
item is set to "Enabled", the system
stops at the end of the POST.
BMC IRQ Disabled
[IRQ 11]
Determines the routing of the BMC
interrupt.
Post Error Pause Disabled
[Enabled]
Specifies whether to stop the POST
at the end of POST if an error
occurs during the POST.
AC-LINK Stay Off
[Last State]
Power On
Specifies the power state when the
AC power to the server is turned off
once and then on.