User`s guide

3-9
To connect the power cord from the server to an interruptive power supply (UPS), use service outlets on the rear of the
UPS.
Refer to the manual that comes with the UPS for details.
When the power cord from the server is connected to a UPS, change the BIOS SETUP utility of the server to link with
power supply from the UPS.
Change the "AC-LINK" parameter under the Server menu of the BIOS SETUP utility. See Chapter 4 for details.
Connect the battery connector when
using an UPS.
Disconnect the connector when
moving the UPS to relocate it.