User`s guide

3-5
When you have selected a server site, hold the server by its bottom with at least three persons and carry it to the site,
then place it slowly and gently.
IMPORTANT:
 Do not hold the server by its front door to lift the server. The front door may disengage
and damage the server.
 Open the stabilizers and secure the server to the site.
 Do not hold the handle of the power module when carrying the server.
Do not place the server in the following places. Placing the server in such places may cause malfunctions of the server.
 Places with drastic changes in temperature (e.g., near a heater, air conditioner, or refrigerator)
 Places with strong vibration
 Places where corrosive gases are present, near chemicals, or where chemicals may be sprayed over
 On a non-antistatic carpet
 Places where objects may fall.
 Places where the power cord of the server must be connected to an AC outlet that shares other devices with
large power consumption.
 Do not install the server next to an equipment that generates power noise (e.g., contact spark at
power-on/power-off of commercial power supply through a relay). If you must install the server close to such
equipment, request your service representative for separate power cabling or noise filter installation.