User`s guide

2-27
When you fail to eject:
When you fail to eject the tray with the Open/Close button and take out the disc from the server, follow the procedure
below.
1. Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2. Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a straightened large paper clip
will make a substitute) into the emergency hole on the front of the optical disk drive and gently push it in until
the tray is ejected.
IMPORTANT:
 Do not use a toothpick or a plastic stick, which could break easily.
 If the above procedure does not succeed, contact your service representative.
3. Hold the tray and pull it out.
4. Take out the disc.
5. Push the tray back into position.