User`s guide

9-81
Removal
Remove the DIMM as described in the following procedure.
NOTES:
 To remove a defective DIMM, check the error message appearing in POST or in NEC
ESMPRO to identify the DIMM socket (group) in which the defective DIMM is
installed.
 The server operates only when at least two DIMMs are installed.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Remove the side cover.
3. Remove the CPU duct cover.
4. Open the levers at the both ends of the socket.
You can then remove the DIMM.
5. Install the components removed earlier.
6. Turn on the power of the server. Then make sure that any error message does not appear in POST.
If an error message appears, write down the message and look it up in Chapter 8.
7. Start the SETUP, then go to [Advanced] → [Memory Configuration] → [Memory Retest] to clear the error
information on the removed DIMM (see Chapter 4).
8. Set [Reset Configuration Data] on the [Advanced] menu to "Yes."
This is required to update the hardware configuration information. See Chapter 4 for details.