User`s guide

9-66
Installation
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Remove the side cover.
3. Remove the additional slot cover and a screw at the same location (height) as the installation slot.
IMPORTANT: Keep the additional slot cover being removed for future use.
4. Make the component side of the board face the bottom of the server, the slowly insert the board aligning the
board connector with the slot on motherboard.
NOTE: For a long-sized board, align the right end of the board with the groove of the
guide rail on the server and then connect the board to the slot.
5. Push the board until the board connector is fully inserted in the slot.
IMPORTANT: If the board cannot be inserted easily, remove it and try again. Applying
too much force on the board may damage it.
6. Fix the board with a screw removed in Step 3.
7. Reinstall the removed components.
8. Turn on the power of the server, and make sure that no error message appears during the POST.
If an error message appears, write down the message and look it up in Chapter 8.
9. Run the BIOS SETUP Utility to set the "Reset Configuration Data" in the "Advanced" menu to "Yes".
This is required to update the hardware configuration information. See Chapter 4 for details.
Guide rail