User`s guide

9-55
6. Push the 5.25-inch device into the device bay carefully.
NOTE: Make sure that the cables are not trapped while the 5.25-inch device is pushed into
the slot.
IMPORTANT: If a 5.25-inch device occupying two slots cannot be inserted easily, lift it
slightly while pushing it.
7. Fix the rails by using the screws removed in step 3.
Single-height device Double-height device
8. Check whether the front face of the installed 5.25-inch device is correctly aligned with the front of the server,
comparing it with the factory-installed optical disk drive.
9. Connect the interface and power cables to the 5.25-inch device installed from the left side of the server.
See Chapter 10 for cable connection.
IMPORTANT: Connector pin bending or incomplete connection may cause a
malfunction to occur. Take care to insert the connector gently.
NOTE: Make sure that the cable is not trapped.
10. Install the removed components.
11. Setup the SCSI BIOS for the SCSI device according to the manual that comes with the SCSI controller.
12. Install the device driver according to the manual that comes with the device.
Removal
To remove the 5.25-inch device, follow the installation procedure in the reverse order.