User`s guide

9-42
Installation (First 2.5-inch HDD Cage)
Install the 2.5-inch HDD cage as described in the following procedure.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Release the lock of the front door by using the security key to open the front door.
3. Remove the side cover.
4. Disconnect all the cables from the rear of 3.5-inch HDD cage.
NOTE: To disconnect SGPIO cable or SAS/SATA cable, hold the connector, unlock it,
then pull it out. Pulling the cable by the cord may damage the connector.
5. Remove the four screws from the 3.5-inch HDD cage, and the four screws from the two dummy covers. Then,
remove the 3.5-inch HDD cage and dummy covers.
NOTE: Keep the removed dummy covers and screws for future use. You will need these
screws to install the 2.5-inch HDD cage.
6. Remove the two screws fixing the dummy cover of the floppy disk drive. Then, remove the dummy cover.