User`s guide

9-22
Power Supply Unit
Your server can contain one or two power supply units.
With redundant power supply installed, the server can ensure continued operation of the system in the unlikely event
one of the power supply units fails.
Installation
Install the power supply unit as described in the following procedure.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Loosen a screw securing the blank cover to remove the cover from the chassis.
IMPORTANT: Keep the removed blank cover and the screw for future use.
3. Insert the power supply unit into the vacant slot until it locks.
IMPORTANT: Insert the power supply unit straight into the slot. To avoid damaging the
power supply unit, do not tilt or twist the unit as you push it into the connector.