User`s guide

9-9
Installation
Install a hard disk drive as described as described in the following procedure. A hard disk drive may be installed in any
other slot in the similar procedure.
IMPORTANT:
 Fill the bays bottom-to-top.
 Hard disk drives are connected with the Internal RAID Controller (SAS/SATA HW
RAID0/1).
 In RAID system, hard disk drives should have the same specification including the
capacity.
NOTE:
Hard disk drives can be installed or removed from the server only by opening the
front door. In the RAID system, hard disk drives may be installed or removed with the
power of the server being on.
1. Release the lock of the front door by using the security key to open the front door.
2. Locate the slot in which the hard disk drive is installed.
There are four slots. The port numbers are defined depending on the locations of the slots (PORT0 to PORT3
from bottom to top).
3. Hold the handle of the dummy tray and remove the dummy tray.
IMPORTANT:
 Keep the dummy tray carefully.
 The purpose of a dummy tray is to increase the cooling effect in the server. Install a
dummy tray in slots not containing a hard disk drive.