User`s guide

8-20
Fail to start the OS with the /3GB switch
→ The system often fails to start the OS with the /3GB switch.
In this case, please adjust the capacity of the user mode area using the /userva switch in reference to
the following URL.
http://support.microsoft.com/kb/316739/en
Problems with the EXPRESSBUILDER
When the server does not boot from the EXPRESSBUILDER DVD, check the following:
 Did you set the EXPRESSBUILDER during POST and restart the server?
→ If you do not set the EXPRESSBUILDER during POST and restart the server, either an error message
will appear or the OS will boot.
 Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server. Use the BIOS setup
utility to change the boot device order to boot the system from the optical disc drive first.
<Menu to check: [Boot]>
If [OS installation ***default***] is selected at the BOOT Selection screen, the following message is displayed.
After this message appears, check the error and take the appropriate corrective action according to the message listed in
the table below.
Message Cause
This EXPRESSBUILDER version was not designed
for this computer.
Insert the correct version and click [OK]. (When you
click [OK], the computer reboots.)
This EXPRESSBUILDER version is not
designed for this server.
Execute the EXPRESSBUILDER on the
compliant server.
EXPRESSBUILDER could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer or the
motherboard may be broken. (When you click [OK],
the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer or the
motherboard may be broken.
This message is shown when the
EXPRESSBUILDER could not find
system-specific information because of a
motherboard exchange and so on.