User`s guide

1-5
Installation, Relocation, Storage, and Connection
WARNING
Disconnect the power cord(s) before installing or removing the server.
Make sure to power off the server and disconnect the power cord(s) from a
power outlet before installing/removing the server. All voltage is removed
only when the power cords are unplugged.
CAUTION
Never attempt to lift the server with two or less persons.
Your server weighs max 36 kg (depending on its hardware configuration).
Carrying the server with two or less persons may strain their back. Hold the
server firmly by its bottom with at least three persons. Do not hold the front
mask to lift the server. The front mask may disengage from the server,
causing personal injury.
Do not install the server in any place other than the ones specified.
Do not install the server in the following places or any places other than the
ones specified in this manual. Failure to follow this instruction may cause a
fire.
a dusty place
a humid place such as near a boiler
a place exposed to direct sunlight
an unstable place
Do not connect any interface cable with the power cord of the server plugged
to a power source.
Make sure to power off the server and unplug the power cord from the power
outlet before installing/removing any optional internal device or
connecting/disconnecting any interface cable to/from the server. If you do not
do so, touching an internal device, cable, or connector may cause an electric
shock or a fire resulted from a short circuit.
Do not use any unauthorized interface cable.
Use only the interface cables provided by the manufacturer and locate a
proper device and connector before connecting a cable. Using an authorized
cable, or connecting a cable to an improper destination may cause a short
circuit, resulting in a fire.
Also observe the following notes when using and connecting an interface
cable.
Do not use any damaged cable connector.
Do not step on the cable.
Do not place any object on the cable.
Do not use the server with loose cable connections.