User`s guide
8-19
The system restarts automatically when a stop error occurs, even though the system is NOT set up to do so:
→ This is not an issue.
Check the System Event Log to confirm that a STOP error occurred.
Cannot turn the power OFF during a blue screen occurrence:
→ If you want to turn off the power during a blue screen, execute a forced power off (forced shut down:
continue to press POWER/SLEEP switch for 4 seconds). The power will not be turned off if you press
the switch just one time.
The PXE boot (network boot) fails or the server is not found on the network:
Is the cable connected properly?
→ Connect the proper cable to the network port on the rear of the server. In addition, make sure that the
cable conforms to the network interface standard.
Is BIOS configuration correct?
→ The internal LAN controller may be disabled in the BIOS Setup utility of the server. Check the BIOS
Setup settings.
Have the protocol and service already been configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and
services are properly specified.
Is the transfer speed correct?
→ Open the network properties dialog box in the control panel to specify identical link speed and duplex
values than the ones specified for the HUB.
The Telnet Service is not installed.
→ Adjust the computer name to 14 characters or less, and then install the Telnet Service according to <How
to install the Telnet Service>.
<How to install the Telnet Service>
1. Click [Run] on Start menu.
2. Type "tlntsvr /service" in the [Open] box, and click [OK].
3. Click the Start menu, point to [Control Panel], click [Computer Management] and then click [Services] to
specify whether the Telnet Service is registered.
* Once the installation of Telnet Service is finished, the computer name can be set to 15 characters or more.
Wake-On-LAN Function
The Remote Power ON/OFF function (Wake-On-LAN) is disabled immediately after the AC power is turned on.
Start Windows 2003 once, perform the steps below, and then shut down the system. Once the server has restarted, the
Remote Power On/Off function is enabled unless the AC power is turned off.
1. Select [Start] - [Administrative Tools] - [Computer Management].
2. Select [Device Manager] - [Network Adapter], and double-click [Intel(R) PRO/1000 EB Network Connection
with I/O Acceleration #n]. Set as follows in the [Detail] tab.
PME: [ON]
Wake On: [Magic Packet]