User`s guide

8-16
Fail to access the hard disk drive:
(Refer to the documentation supplied with the RAID Controller.)
 Is the hard disk drive applicable to the server?
→ Operation of any device that is not authorized by the manufacturer is not guaranteed.
 Is the hard disk drive properly installed?
→ Make sure to lock the hard disk drive with the lever on its handle. The hard disk drive is not connected
to the internal connector when it is not fully inserted (see Chapter 9).
Fail to access the (internal or external) SCSI devices:
 Is the SCSI device applicable to the server?
→ Operation of any SCSI device that is not authorized by the manufacturer is not guaranteed.
 Has the cable connection changed?
→ See Chapter 10 for cable connection.
 Are the SCSI devices properly configured?
→ When external SCSI devices are connected to the server, device settings, including SCSI ID and
terminator, are required. Refer to the manual that comes with the SCSI device for details.
 Is the cable length exceeded?
→ Refer to the manual that comes with the SCSI device for details.
 Are the SCSI controllers (including the optional controllers) properly configured?
→ If an optional SCSI controller is installed in the server, and if SCSI devices connected to it, use the
BIOS setup utility that comes with the optional SCSI controller for proper configuration. Refer to the
manual that comes with the optional SCSI controller for details.
Event logs when using the Intel Network adapter teaming
Event Type: Warning
Event Source: IANSMiniport
Event Category: None
Event ID: 11
Description: Adapter link down: Intel(R)PRO/1000 ----
Event Type: Warning
Event Source: IANSMiniport
Event Category: None
Event ID: 13
Description: Intel(R)PRO/1000 ---- has been deactivated from the team.
Event Type: Error
Event Source: IANSMiniport
Event Category: None
Event ID: 16
Description: Team #0: The last adapter has lost link.
Team network connection has been lost.