User`s guide

8-11
Error
code
Error message Recommended Action
02D1 System Memory exceeds the CPU's caching
limit.
02F4 EISA CMOS not write able.
02F5 DMA Test Failed.
02F6 Software NMI Failed.
02F7 Fail-safe Timer NMI Failed.
Contact your service representative.
0611 IDE configuration changed Check the IDE configuration.
0612 IDE configuration error - device disabled
0613 Com A configuration changed Check the COM A configuration.
0614 Com A config. error - device disabled
0615 Com B configuration changed Check the COM B configuration.
0616 Com B config. error - device disabled
0B22 CPUs are installed out of order. Contact your service representative to replace the CPU.
0B28 Unsupported CPU detected on CPU Socket
1.
0B29 Unsupported CPU detected on CPU Socket
2.
Make sure that the server supports the CPU. If you are
not sure, contact your service representative.
0B42 Resource Conflict
0B43 Warning: IRQ not configured
0B45 System configuration Data Write Error
Contact your service representative.
0B50 Processor #1 with error taken off line.
0B51 Processor #2 with error taken off line.
0B5F Forced to use Processor with error
The system start was forced. Contact your service
representative.
0B60 DIMM group #1 has been disabled
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
0B63 DIMM group #4 has been disabled
0B64 DIMM group #5 has been disabled
0B65 DIMM group #6 has been disabled
Contact your service representative.
0B6F DIMM group with error is enabled.
0B70 The error occurred during temperature
sensor reading.
Contact your service representative.
0B71 System Temperature out of the range. Contact your service representative to replace the fan.
0B74 The error occurred during voltage sensor
reading.
Contact your service representative.
0B75 System voltage out of the range.
0B80 BMC Memory Test Failed.
Turn off the power once and then on again to start the
server. If it does not correct the error, contact your
service representative.
0B81
BMC Firmware Code Area CRC check
failed.
0B82 BMC core Hardware failure.
0B83 BMC 1BF or 0BF check failed.
0B8A BMC SEL area full.
Start SETUP and select [Server] - [Event Log
Configuration] - [Clear All Error Logs] and press Enter to
clear the event logs.