User`s guide

1-4
Power Supply and Power Cord Use
WARNING
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to
follow this warning may cause an electric shock.
CAUTION
Plug in to a proper power source.
Use a grounded wall outlet of the specified voltage. Using an improper power
source may cause a fire or a power leak.
Do not install the server in a place where you need an extension cord. Using
a cord that does not meet the power specifications of your server may heat
up the cord and cause a fire.
Do not connect the power cord to an outlet that has an illegal number of
connections.
The electric current exceeding the rated flow overheats the outlet, and may
cause a fire.
Do not pull on the cable when disconnecting it.
When disconnecting the cable from the device, hold the cable connector and
pull it straight out. Pulling the cable out by the cable portion or giving
mechanical stress to the connector could damage the cables and connectors
and result in an electrical shock hazard or a fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug (imperfect
contact) may cause a fire. Heat will also be generated if condensation forms on
the dusty blades of the halfway inserted plug, increasing the possibility of fire.
Use only the authorized power cord.
Use only the power cord that comes with your server. Using an unauthorized
power cord may cause a fire if the electric current exceeds the rated flow.
Also observe the following to prevent an electric shock or fire caused by a
damaged cord.
Do not stretch the cord harness.
Do not pinch the power cord.
Do not bend the power cord.
Keep chemicals away from the power cord.
Do not twist the power cord.
Do not place any object on the power cord.
Do not bundle power cords.
Do not alter, modify, or repair the power cord.
Do not secure the power cord with staples or equivalents.
Do not use a damaged power cord. (Replace a damaged power cord with
a new one of the same specifications. Ask your service representative for
replacement.)