User`s guide

7-9
RELOCATING/STORING THE SERVER
Follow the procedure below to relocate or store the server:
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
Never attempt to lift the server only by yourself.
Do not install the server in any place other than specified.
Do not connect/disconnect any interface cable with the power cord of the
server plugged to a power source.
IMPORTANT:
 If the server needs to be relocated or stored, contact your service representative.
 Make sure to make a backup copy of your valuable data in the hard disk drive, if any.
 Make sure not to shock the hard disk drives when relocating the server.
1. Take any media out of the server, if any.
2. Power off the server (the POWER/SLEEP lamp goes off).
3. Unplug the power cord of the server from its power outlet.
4. Remove all the cables from the server.
5. Hold the server by its bottom to carry the server.
IMPORTANT: Do not hold the front mask to lift the server. The front mask may
disengage from the server, causing personal injuries.
6. Protect the server with the shock-absorbing materials, and pack it securely.