User`s guide

7-7

6. Select [Test and diagnostics].

Select [End-User Mode] and the system diagnostics starts. The diagnostics are completed in approximately

three minutes. Once the diagnostics are completed, the displayed screen changes as shown below:

Diagnostics tool title

[Enter] Detail Information [ESC] Return to Enduser Menu

Test End

eDoLi (TEst & Diagnosis On Linux) Ver001.00 (Build020901.1.1m)

MEM Memory 16 count NormalEnd

CACHE Cache 49 count NormalEnd

<SCSI>

HDD_02:000 DK32DJ-36W 89 count NormalEnd

Start 10:06:58 End 10:09:58 Pass 000:03:00 TestTime 000:03:00

est End : NormalEnd 03 AbnormalEnd 00 ForceEnd 00

Guide line

Test summary window

Test result

Test window title

– Diagnostics tool title

Shows the name and version of the diagnostic tool.

– Test window title

Shows the diagnostics progress. "Test End" is displayed when the diagnostics are completed.

– Test result

Shows the start, end, elapsed time and completion status of the diagnostics.

– Guide line

– Test summary window

Shows the results of each test that executed the diagnostics. Move the cursor and press the Enter key on

the cursor line to display the details of the test.

When an error is detected by the system diagnostics, the relevant test result in the test Summary window is

highlighted in red, and "Abnormal End" is displayed in the result on the right side.

Move the cursor to the test that detected the error, and press the Enter key. Record the error message that has

been output to the Detail Information screen and contact your service representative.