User`s guide

5-19
Optional Network Board Driver
When using a manufacturer-approved Network Board, the network driver will be installed automatically. Therefore, the
driver attached to the Network board should not be used.
To use optional Network Boards, install the driver stored in EXPRESSBUILDER DVD.
When using the 100BASE-T protocol:
"\004\win\winnt\dotnet\dl3\pro100\win32"
When using the 1000BASE-T protocol:
"\004\win\winnt\dotnet\dl3\pro1000\win32"
If the procedure of installation is not clear, refer to the installation procedure described in the section "Installation of the
Optional Network Board Driver".
When using the 10GbE protocol:
Please refer to the installation manual provided with the board.
Installation of the Optional Network Board Driver
1.
Start the Device Manager.
2. Click [Network adapters] and double-click [(Network Adapter Name)].
The [(Network Adapter Name) Properties] appears.
NOTE: [(Intel(R) PRO/1000...)] is the name of On-Board adapter. All the other names
show the Optional Network Board.
3. Click the [Driver] tab and click [Update Driver...].
The [Hardware Update Wizard] appears.
4. Select the [Install from a list or specific location(Advanced)] radio button and click [Next].
5. Select the [Search for the best driver in these locations] radio button and check off the [Search removable
media (floppy, CD-ROM...)] check box.
6. Check the [Include this location in the search] check box:
¾ When using 100BASE-T cards, specify [\004\win\winnt\dotnet\dl3\pro100\win32]. Click [Next].
¾ When using 1000BASE-T cards, specify [\004\win\winnt\dotnet\dl3\pro1000\win32]. Click [Next].
7. Click [Finish].