Manualshelf

User`s guide

ManualsBrandsBull ManualsComputer equipmentNovaScale T860 E1
131132133134135136137138139140
4-68
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2. Remove the left side cover (see Chapter 9).
3. Change the jumper switch setting from "Protect" to "Clear".
IMPORTANT:
Use the clip over the jumper pins 1 and 2 on the motherboard.
Do not lose the clip.
4. After three seconds, reinstall the jumper.
5. Reinstall the server and then turn on the power.
6. Press F2 during POST to run the BIOS Setup utility, and configure the motherboard again.
Clearing the Password
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2. Remove the left side cover (see Chapter 9).
3. Change the jumper switching setting from "Protect" to "Clear".
IMPORTANT:
Use the clip over the jumper pins 1 and 2 on the motherboard.
Do not lose the clip.
4. Reinstall the server and then turn on the power.
5. Press F2 during POST to run the BIOS Setup utility, and set the password again.
6. Remove the left side cover (see Chapter 9).
7. Power off the server, and change the jumper switch setting from "Clear" to "Protect".
8. Reassemble the server.