Installation guide

User Guide
40
www.bull.com
Upgrading to Microsoft
®
Windows Server
®
2008
This chapter describes guidelines for upgrading Microsoft
®
Windows Server
®
2003 to
Microsoft
®
Windows Server
®
2008.
Overview
The Microsoft
®
Windows Server
®
2008 upgrade flow is shown below. Be sure to
remove the installed graphics accelerator driver and PROSet before you upgrade.
1. “Before You Upgrade” on page 41.
2. See “Important Instructions” on page 41.
3. See“Before You Start” on page 9 and “Important Instructions” on page 10.
4. Remove the installed “Graphic Accelerator Driver” on page 42.
5. Remove “PROSet” on page 42.
6. Install and setup “BIOS Update” on page 14.
7. Start “Upgrading Windows” on page 43.
8. “On the Server Manager screen, confirm your user settings.” on page 43.
9. See “Installing Drivers and Configuring Driver Settings” on page 24.
10. See “Installing Drivers after the Upgrade” on page 45.
11. Configure “Fault Recovery Settings” on page 30.
Notes: the instructions below are given with a Start menu
configuration. To check your configuration proceed as follows:
■ Right click on the task bar ,and click Properties
■ In the Start Menu tab, check Start Menu, and click OK.