Installation guide

User Guide
27
www.bull.com
Removing a Team
1. Open Control Panel. Under System and Maintenance, click Open Device
Manager
to start Device Manager.
2. Open Network adapters, and double-click a teamed adapter.
3. Select the Settings tab, and click Remove Team.
4. When the Team Settings pop-up box appears, click Yes.
5. Under Device Manager, go to Network adapters. Make sure that no adapter is
teamed.
Restart the system.
Caution
■ Adapter Fault Tolerance (AFT) and Adaptive Load Balancing
(ALB) are not available when ServerCore is in use.
■ Be sure to configure AFT and ALB after you boot the system
following the driver installation.
■ To use AFT, we recommend you to connect the network
adapters to the same L2 switching hub. You may use differ-
ent switching hubs, but cascade them over the same net-
work.
■ To configure ALB, connect the network adapters only to the
L2 switching hub.
■ To replace a motherboard or an optional network card, you
must first remove the team and create it again after the
replacement.