Installation guide

User Guide
12
www.bull.com
■ Adaptec SCSI Card 29160LP
■ Adaptec SCSI card 29320LPE
■ Emulex LightPulse® LPe1150 Fibre Channel controller
■ Emulex LightPulse® LPe11002 Fibre Channel controller (2ch)
BULL NovaScale R480 E1
■ LSI Logic MegaRAID SAS PCI Express ROMB, on the mother board
■ LSI Logic MegaRAID SAS 8480E RAID Controller
■ Emulex LightPulse® LPe1150
■ Emulex LightPulse® LPe11002
■ Intel® Pro/1000 PT Server Adapter
Updating Your System
After Microsoft
®
Windows Server
®
2008 has been installed, you need to update your
system using the Driver Set. To update your system, see “Updating the System”,
page 22.
Reinstalling an Operating System in a Dynamic Disk
A basic disk that has been upgraded to a dynamic disk may contain an additional
partition other than the partition where you reinstall the operating system. To reinstall
the operating system in the dynamic disk without removing the old partition(s):
■ Choose the partition where an old operating system was located.
■ To format the partition, choose Use the current File System.
Installing on the Mirrored Volume
When re-installing the OS to a hard disk drive which has been upgraded to Dynamic
Disk, only the simple dynamic volume is available for installation.
To install the OS on a volume that is mirrored using Disk Management, proceed as
follows:
1. Invalidate the mirroring.
2. Reset to the basic disk before the installation.
3. Validate the mirroring again after the installation.
Note: You can create, invalidate, or delete the mirror
volume by using Disk Management in Computer Management.