User`s guide

User Guide
27
www.bull.com
4. Reconnect the AC power, power up the system.
5. When the system begins beeping, power it down and disconnect the AC power.
6. Replace the jumper on pins 1 and 2.
7. Close the server chassis.
Reconnect the AC power and power up the system.
BIOS Select Jumper
This jumper is used to select the BIOS image from which the system will boot.
Figure 9: BIOS Select Jumper (J1J3)
Note: for more information on the BIOS Update process,
please refer to “Updating BIOS” on page 285.
Table 4: Configuration Jumper Descriptions
Pins Jumper Purpose
1-2 Force BIOS to bank 2
2-3 System is configured for normal operation (bank 1) (Default)