User`s guide

User Guide
26
www.bull.com
2. Open the server chassis.
3. Move the jumper (J1J2) from the normal operation position on pins 1 and 2
(Password Clear Protect), to the pins 2 and 3 (Password Clear Erase position),
as indicated in the following diagram.
Figure 7: Password Clear Jumper
4. Reconnect the AC power, power up the system.
5. Power down the system and disconnect the AC power.
6. Return the Password Clear jumper to the Password Clear Protect position,
covering pins 1 and 2.
7. Close the server chassis.
8. Reconnect the AC power and power up the server.
Clearing the CMOS
If you are not able to access the BIOS setup screens, the CMOS Clear jumper will need
to be used to reset the configuration RAM.
1. Power down the system and disconnect the AC power.
2. Open the server.
3. Move the jumper (J1J1) from the normal operation position (pins 1 and 2) to
pins 2 and 3 (CMOS Clear Force Erase position), as indicated in the following
diagram.
Figure 8: CMOS Clear Jumper
AF000187
3
2
J1J2
3
2
Default
CLEAR
CMOS
Default
CLEAR
PASSWORD
J1J1
CMOS
CLR
PASSWORD
CLR
AF000187
3
2
J1J2
3
2
Default
CLEAR
CMOS
Default
CLEAR
PASSWORD
J1J1
CMOS
CLR
PASSWORD
CLR