User`s guide

User Guide
217
www.bull.com
Windows Server 2003 Installation
This section explains how to perform a clean installation of Windows Server 2003.
1. Power on the system.
2. Insert the Windows Server 2003 disc in the optical device drive.
3. Press Ctrl + Alt + Delete to reset the system.
If a bootable operating system is already installed on the hard disk, press Enter
while the message "Press any key to boot from CD..." is displayed at the top of
the screen.
If no bootable operating system is installed on the hard disk, this step is
unnecessary.
The Windows Server 2003 setup screen will be displayed. If the screen is not
displayed, Enter was not pressed properly. Retry after turning the system off
then on again.
4. If a RAID controller is installed, press F6 while:
– "Setup is inspecting your computer's hardware configuration..." is displayed.
– A screen with a solid blue background is displayed.
Note: There is no visible indication on screen when F6 has
been pressed.
5. When the following message is displayed, press S.
The following message is displayed.
6. Insert the Windows Server 2003 OEM-DISK for ExpressBuilder into the
floppy drive, and press Enter.
7. Follow the on-screen instructions to complete the installation.
8. After the installation is completed, be sure to follow the procedures described
in “Updating the System” on page 219 and “Installing Drivers or Software”
on page 220.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices.
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.