User`s guide

User Guide
202
www.bull.com
The following table shows the normal settings for the Adaptec SCSI Utility and
provides a place for you to record any changes you make to these settings.
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
SCSI Disk Utilities
This utility scans the SCSI bus for SCSI devices, and reports a description of each
device. Run this utility before configuring SCSI devices.
To enter the utility, select SCSI Disk Utilities on the Options menu.
The SCSI ID scan begins displaying the message as shown below.
Table 11: SCSISelect Utility Setup Configurations
OPTION RECOMMENDED SETTING OR
DISPLAY ONLY
YOUR
CONFIGURATION
SCSI Bus Interface Definitions
SCSI Controller ID 7
SCSI Controller Parity Enabled
SCSI Controller Termination Enabled
Additional Options
Boot Device Configuration Press ENTER for menu
Master SCSI Controller 29320ALP slot 01 03:01:00
Boot SCSI Controller 29320ALP slot 01 03:01:00
SCSI Device Configuration Press ENTER for menu
Sync Transfer Rate (MB/Sec) 320
Packetized Yes
QAS Yes
Initiate Wide Negotiation Yes
Enable Disconnection Yes
Send Start Unit Command Yes
BIOS Multiple LUN Support
No
1
Include in BIOS Scan
Yes
1
Advanced Configuration Press ENTER for menu.
Reset SCSI Bus at IC
Initialization
Enabled
Display <Ctrl-A> Messages
During BIOS Initialization
Enabled
Extended Int13 Translation for
DOS
Drives >1 GByte
Enabled
POST Display Mode Verbose
SCSI Controller Int13 Support
Enabled
1
Domain Validation
Enabled
1
Support Removable Disks
Under Int13 as Fixed Disks
Disabled
1, 2
BIOS Support for Bootable
CDROM
Enabled
1