User`s guide

User Guide
180
www.bull.com
Cabling IDE Devices
The IDE Cable
The following figure shows a typical three-connector IDE cable. If the IDE cable is not
keyed with a connector tab, align the coloured edge (Pin 1) of the cable with the pin 1
side of the drive connector.
Figure 96: Three-connector IDE Cable
A - Connects to the motherboard IDE port
B - Red edge (Pin 1)
C - Connects to IDE devices
System Power Cables
Power cables come from the power supply and are attached to standard storage devices.
System power cables vary in length and provide connector sizes to accommodate a
variety of supported storage configurations. Power cable connectors are keyed to fit
only in the correct position.
Figure 97: IDE Storage Device Power Cable Connector