User`s guide

User Guide

177

www.bull.com

6. Record the type and serial number of the add-in board in your equipment log

7. Set jumpers or switches on the board according to the manufacturer’s

instructions.

8. Hold the PCI add-in board by its top edge or upper corners. Firmly press the

add-in board into an expansion slot on the server board (A).

9. Close the back panel PCI Add-in Card Retention Device (B).

Figure 92: Installing the PCI Add-in Board

10. Repeat the previous steps until all PCI add-in boards are installed.

11. Attach cables, if necessary.

12. Replace the front panel. See “Replacing the Front Panel” on page 143.

13. Replace the left side cover. See “Replacing the Left Side Cover” on page 141.

Removing an Expansion Card

Caution

PCI add-in boards are extremely sensitive to electric static

discharge (ESD) and always require careful handling. After

removing the add-in board from its protective wrapper or from

the server board, place it with the component side up on a

grounded, static-free surface or conductive foam pad. Do not

slide the add-in board over any surface.

1. Remove the left side cover. See “Removing the Left Side Cover” on page 140.

TP01745