User`s guide

User Guide
169
www.bull.com
14. Set the heat sink over the processor, lining up the four captive screws with the
four posts surrounding the processor.
Caution
The heat sink has Thermal Interface Material (TIM) located on
the bottom of it. Use caution when you unpack the heat sink so
you do not damage the TIM.
15. Loosely screw in the captive screws on the heat sink corners in a diagonal
manner. Do no fully tighten one screw before tightening another.
Gradually and equally tighten each captive screw until each is firmly tightened.
Figure 87: Installing the Heat Sink
AF000179
2
3
1
4