User`s guide

User Guide

167

www.bull.com

4. Unplug the processor fan cable from the server board.

5. Loosen the four captive screws on the corners of the heat sink.

6. Twist the heat sink slightly to break the seal between the heat sink and the

processor.

7. Lift the heat sink from the processor.

Caution

If it does not pull up easily, twist the heat sink again. Do not

force the heat sink from the processor. Doing so could damage

the processor.

8. Lift the processor lever.

Figure 83: Lifting the Processor Lever

9. Raise the CPU load plate.

Push the rear tab with your finger tip (A) to bring the front end of the load plate up

slightly. Open the load plate as shown (B)

Figure 84: Raising the CPU Load Plate

AF000176

AF000177