User`s guide

User Guide
165
www.bull.com
2. Connect a SAS/SATA data cable (B) to each appropriate SAS/SATA connector
on the SAS/SATA backplane.
3. Connect the IPMB cable (C).
4. Connect the fan power to the FAN1 connector on the motherboard.
Figure 80: Connecting the Six-drive Hot Swap Drive Cage Backplane with Expander
(fan bracket not shown in the illustration for clarity)
If you are installing a six-drive SCSI hot swap drive cage:
1. Connect the two power cables (A) to the two power cable connectors on the
SCSI backplane.
2. Connect the SCSI data cable (B) to the SCSI connector on the SCSI backplane.
3. (Optional, dependent on server board installed) Connect the IPMB header (C)
to the IPMB connector on the SCSI backplane.
4. Connect the fan power to the FAN1 connector on the motherboard.
Figure 81: Cabling the SCSI Hot Swap Drive Cage
6-Drive Expander HS Backplane
A
C
B
SAS 0
SAS 1
AF00448
TP02056
A
B
C