User`s guide

User Guide
164
www.bull.com
1. Connect the two power cables (A) to the power cable connectors on the SAS/
SATA backplane.
2. Connect a SAS/SATA data cable (B) to each appropriate SAS/SATA connector
on the SAS/SATA backplane.
3. Connect the IPMB cable (C).
4. Connect the fan power to the FAN1 connector on the motherboard.
Figure 79: Connecting the Six-drive SAS/SATA Hot-Swap
Drive Cage Backplane without Expander
(fan bracket not shown in the illustration for clarity)
Connecting a SAS/SATA hot swap backplane with expander
Caution
SATA controllers cannot be used with an expander backplane.
1. Connect the two power cables (A) to the power cable connectors on the SAS/
SATA backplane.