User`s guide

User Guide
161
www.bull.com
Notes: For proper airflow, the drive carrier must be replaced
in the chassis, even if no hard drive is installed in it.
Figure 75: Re-installing the Drive Carrier in the Hot Swap Drive Cage
7. Close the drive bay access door.
Figure 76: Closing the Drive Bay Access Door
Cabling the Hot-Swap Hard Disk Drive Cages
Refer to the instructions below should you have to disconnect and reconnect the
backplane and server board/RAID controller card cables.
Cable instructions differ depending upon whether you are installing a SCSI or SAS/
SATA hot swap drive cage.
AF000313
AF000314