User`s guide

User Guide
144
www.bull.com
Installing or Removing a 5.25-inch Device
This section of the chapter describes how to add and remove 5.25-inch devices. You
can install an optical disc drive, tape backup unit, or other 5.25-inch devices in the
additional 5.25-inch bay.
See the installation instructions included with those items for specific installation
information. Before installing a 5.25-inch device, read the section “Preparing IDE
Devices” on page 188.
Note: Additional power and/or data cables may be included
with your system. In this case, store them in a safe place, you
will need them if you decide to add additional drives.
Adding a 5.25-inch Device
1. Remove the left side cover. See “Removing the Left Side Cover” on page 140.
2. Remove the front panel. See “Removing the Front Panel” on page 142.
3. Remove the EMI shield from the 5.25-inch device drive bay (A).
4. Move the latch to the “unlock” position (B).
Figure 48: Removing 5.25-inch Drive EMI Shield
TP00651
A
B